GRAINFARM
Suitable for grain growing enterprises where anticipated usage is stockfloats, semi-trailer grain trucks, bogie-drive fuel tankers, large tractors and wide implements.
Concrete Base
- Reinforced concrete base with cast in protection channels on leading edges, cast in anchor points.
- Provision made in concrete base for cross road drainage.
Steel Grid Component
- Mesh sides fabricated from pre-galvanised RHS with stiffeners welded in across support members to stop sheep walking on these support members, bolt onto the end bars of the grid.
- The Rectangular Hollow Section rails are galvanised for long life.
Specification
| Width across road | 4020mm |
| Width from tip to tip of mesh sides | 4960mm |
| Length going along the road | 2100mm |
| Depth of concrete base | 500mm |
| Nominal capacity | W7 wheel load, 8 tonne axle load with safety factor |
| Grid rail size | 100x50x4.0 grade 350 RHS |
Installation
 |
 |
 |
||
| Prepare the site for your grid before the carrier arrives. We recommend excavation of the pit to sufficient depth to achieve suitable foundation, but also to keep the finished height of the grid above ground level. This minimises silting up of the pit and also acts as a speed trap. A minimum of 50mm layer of sand or crusher dust should be screeded level across the bottom of the pit to reduce the possibility of point loading. | When the carrier arrives, the grid can be lifted by the trucks crane into place. | Backfill carefully, ramming the earth in layers. After several weeks use, this fill will have settled and may need to be topped up to avoid depressions at the leading edges. |
Additional Elements
 |
 |
 |
|||
| MESH SIDES | REFLECTIVE SIGNS | FENCING | |||
 |
|
|
|||
